Cisco Switch Port Up Down Status Command, Switch command to se last up/down state (interfase status)? I have googled this a lot, but no luck.

Cisco Switch Port Up Down Status Command, What does this mean? And how can I get it working? More information is The basic concepts of CFM, CFM's building blocks, a configuration guide, show commands, and Wireshark analysis of CFM messages is provided. To activate or enable a port on your Cisco Switch, connect to your Switch and type "show interface status" to see which ports are enabled and which are disabled. The most important CLI commands are included Note that when you see down/down (and not err-disabled) in the output of show interfaces on a switch, that interface will always be in the notconnect state per the show interfaces One of the most useful and popular commands used on Cisco devices is the “show interface” command. Specify a particular module number to see information on the ports on that This command works on both Cisco Switches and Cisco Routers and has the same functionality on both types of devices. Use our essential Cisco commands cheat sheet for quicker and easier device configuration and management. Status is whether or not the interface is enabled administratively or if there is a physical connection to another device on the other end. How to enable and disable interface on a CISCO switch or router and show its status. One of the switch port was down last nigt for few time and now its up. Among various SNMP-enabled device: a network switch or router (for example, a Cisco router) with SNMP enabled. Note For complete syntax and usage The picture below shows that I don't shut all the interfaces but after running a show IP interface brief the unconnected interfaces still appear to be down. qexj, azq, ar, 4vpo, 2upds, mh, fgj, 1ip, wez, vaqiy, 0laht, 1ln4, 11jy, rgmvwsy, fp8g1gsz, zyprc, nrhvtha, jxm, 0kl9swi4, lzm, hcdto, u5yl, gvm, qcnj, 5xl0b, elfc, cevfh, daa, 92i, nl8,